Message Board / FORUM

I have inadvertantly deleted the default 172.How can I load it back in.

If like me you kept getting the "since you crashed" error at the end of the fs2004 atp checkride, I know why this is. To pass you must pass over the outer marker on the 339 outbound leg then turn to 294 when marker sounds. After 70 seconds turn RIGHT to 114 course select app.You will pass over the outer marker and the programme will see that you are trying to land, without the markers it does not know and assumes you have crashed.

Ok then I don't know really.. maybe you have failures simulated (check realism/failure settings). Btw, do not reply multiple times, then I have to keep editing and removing... thx

The fuel is fine because I had it setup auto fully, there's on icing, and it happens only in the air, just after 5-8 minutes after depature. It happes on an Airbus, B-737, B-747, Cessna, whatever plane I chose

Checked your fuel quantity and how it's devided across your tanks (on larger aircraft), and anti-icing? Does it only happen in the air, at the ground, at high altitude, when..?

I have a problem since the last 4 weeks every aircraft I flight the engines turned off, every 5 minutes, I had to turn them on (ctrl+e), but its turn off again every 5-8 mins. It is happening with all the aircrafts. Microsoft tried to help me but they did not respond my email, could somebody help on this. Many Thanks

When I open fs2004 I get this message and a crash back to the desktop.

I don't know... check the ATIS of the arrival airport to see the QFE or just press the "B" key to set the local pressure in the altimeter. Do this when passing the transition level and maybe again just before landing (to be sure). I assume you have sufficient theoretical knowledge if you're taking the checkride now... 29.92 is used above the transition altitude. Good luck, I think that's all I can tell you.

the pressure setting is 29.29 the aircraft is default 737. Is this the right setting

Have you not changed the weather settings, or forgot to set the QFE (air pressure at the airport)? A wrong pressure setting could make the simulator think you are somewhat underground. Are you not using an add-on aircraft also?

«« previous    ||   NEXT PAGE »»